SensorModule for JetCat ECU V6
SensorModule for JetCat ECU V10


Delivers instant knowledge of turbine health and fuel quantity

The module will monitor the following parameters

- RPM of turbine, with alarm for over or under speed
- RPM of Prop
(only turboprop models), with alarm for overspeed
- EGT, with alarm for over or under temp
- State and OffState
- Throttle Position
- Fuelflow
- Fuel level, with alarm for lov fuel level
- ECU Battery voltage, with alarm for low batt voltage
- Speed
(with JetCat speed sensor connected to ECU), with alarm for overspeed
- Max Speed
(with JetCat speed sensor connected to ECU)
- Avg. Speed
(with JetCat speed sensor connected to ECU)

Module connected to P60 in teststand


Module connected to tucano with SPT5 Turboprop

The module will use the built-in function in the ECU, to monitor fuel level

Included with module is cables for connection to JetCat ECU, and Multiplex Receiver

 

Fully configurable with free Windows software downloaded from support page

Note : a Multiplex interface cable are needed to configure the module

use Multiplex USB receiver interface cable #55149,  or old model RS232 receiver cable #85150 (not included)


Prices and Versions

Basic Version, all options included : 69 Euro including p&p  
Note : Works only on ECU firmware V6, and the new V10 ECU

Sorry, The module has sold out